30
20306745
VWDV70 Series Gas Fireplace
FINAL INSTALLATION
GLASS AND STONE PLACEMENT
If you will be installing the optional accessory log set,
Model LKW70, install the two (2) rear logs
before
installing
the decorative colored glass. Refer to Accessory Log Set
Installation, Page 31.
Find the pre-molded 4-stone assembly. Place these stones
over the pilot assembly by aligning the holes in the bottom
of the stone assembly with the pins on either side of the
pilot assembly.
Figure 45
NOTE:
The 4-stone assembly must be installed before any
decorative glass is installed.
CAUTION:
Do not allow these stones to contact any part
of the pilot parts. Do not allow any of the pilot
fl
ames to
Figure 44 -
Glass Placement
LG1100
contact any stones. Do not allow stones to sit directly on
burner ports or in
fl
ames.
Place three (3) pieces of hearth glass lenses (supplied)
into opening on hearth in front of burner.
Unpack all decorative colored glass and stones included in
kit. Carefully mix the two colors of decorative glass. Place
the decorative colored glass above and outside the burner
to cover hearth area. Spread decorative glass in a single
layer.
Figure 44
CAUTION:
Do not place decorative colored glass over
the open gap between burner and hearth as this will block
the air
fl
ow and affect the performance of the unit. Keep
decorative glass behind bracket surrounding the burner
and hearth.
Figure 45
LG1113
Figure 46
LG1114
Find the four (4) large stones. Place them along the rear
wall approximately equally spaced as shown in
Figure 46
.
Place the remaining stones randomly outside the burner
area over the hearth and hearth glass all around the burner.
Figure 47
Turn burner on and adjust decorative glass over the ported
burner area to achieve an even, clean
fl
ame.
Replace glass door frame.
