Vermes MDS 3000 Series, Руководство пользователя

Страница: 37 / 77

VTK ‐ VS ‐ BA ‐ 004e ‐ B | User Manual MDS 3200A
| Operation
37
6.8 Loading the Factory Settings
By recalling the Factory Settings (implemented by the manufacturer) , you return to a prede ‐
fined starting position. This is useful to start the input of a new parameter set.
These are the values contained in the Factory Settings:
RI = 0,50 ms, FA = 0.20 ms, OT = 0 ms, NL = 90%, DL 10.0 ms and NP = 1
Step 1: Press [recall] .
Step 2: [Downward Arrow] immediately opens this parameter set.
Step 3: [enter] the selection.
IMPORTANT NOTE!
Press [esc] to abort.
6.9 Switching OFF the MDS 3200A
Step 1: The current dispensing cycle must be completed, so that the valve is in home position.
Step 2: Lower the supply pressure to atmospheric pressure (because in initial position, the
valve is still opened) . Disengage the pneumatic supply. If required, close the car ‐
tridge by using locking pin MDT 309.
Step 3: Switch OFF the control unit (ON/OFF button at the rear end).
Step 4: Disconnect the valve from fluid supply.
Step 5: Remove all cables from the valve.
Step 6: Unscrew the screws used for fixing the valve in place.
After working with self ‐ curing substances, immediate cleaning is advisable
in order to avoid clogging. This concerns the valve itself and all parts in con ‐
tact with the fluid. The valve and its subcomponents have to be dismantled
and cleaned, as described in the chapter “Cleaning”.
CAUTION! (prepare cleaning)
It is recommended to prepare the cleaning procedure in advance.
Do not drop the device or its subcomponents.