Vendlet STANDARD, Руководство пользователя

Страница: 38 / 40

PART 3 - Technical manual
38
ENVIRONMENTAL CONDITIONS AND
DISPOSAL
Environmental conditions
Operation:
Temperature 5 – 40 °C
Air humidity 20 – 90% at 30°C – no condensation
Atmospheric
pressure
700 – 1060 hPa
Storage:
Temperature 0 – +50 °C
Air humidity 20 – 90% at 30°C – no condensation
Atmospheric
pressure
700 – 1060 hPa
Transport:
Take the necessary precautions to protect the electric components against
rough jolts, shocks etc.
After transportation at low temperatures the motors in the bars might
work irregularly until they have been warmed up to normal room temper-
ature.
Disposal
Do not discard VENDLET Standard with general household
waste. On disposal of VENDLET Standard, Vendlet ApS recom-
mends that the system be divided into individual parts and
components for recycling.
The control unit and the hand control must be disposed of as
electronic waste. Furthermore, it may be divided into metal
waste, cable waste, electronic waste, and reusable plastic.
Turning sheets and slide sheets can be washed and handed in
for recycling. However, very dirty sheets must be disposed of
as combustible waste.
ESSENTIAL PERFORMANCE
This equipment is compliant with IEC 60601-1-2, meaning that
no loss of essential performance is found due to electromag-
netic disturbances. The essential performance of VENDLET
Standard refers to control of the bars and corner posts using
the hand control (see page 8-9 - How VENDLET Standard
works).
The electrical circuit is equipped with a double fault safety
which requires both a power request and a keystroke on the
hand control to operate.
In the unexpected case of corruption of the electrical system
due to electromagnetic disturbances, the expected outcome is
a non-functioning electronics box without any motor function.
Under these circumstances, VENDLET Standard still functions
as a side rail. Refer to page 21, “evacuation”, for instructions of
manual lowering of the side rails.
Use of this equipment adjacent to or stacked with
other equipment should be avoided as it might re-
sult in irregular operation. If such use is necessary,
the equipment should be observed to verify that it
is operating as intended.
Portable Radio Frequency (RF) communication
equipment (including antenna cables and external
antennas) should be used no closer than 30 cm
(12 inches) to any part of the VENDLET Standard,
including cables specified by Vendlet ApS, as it
can lead to irregularities in the operation of the
system.