Vendlet STANDARD, Руководство пользователя

Страница: 33 / 40

PART 3 - Technical manual
33
FINAL INSPECTION CHECKLIST
Always perform a final inspection after completing the in-
stallation. The final inspection is carried out by following the
checklist below. The list may also be downloaded at www.
vendlet.com.
Final inspection checklist Yes No
Is VENDLET Standard mounted by a person with relevant training?
Is the combined weight of the client, VENDLET Standard and any other equipment on/in the bed below or equal to
the max. safe working load of the bed?
Have the side rail dimensioning requirements been met (length and height)? (Page 26)
Can both side rails be raised and lowed without problems?
Are all corner posts adjusted to the same height according to the mattress? (Page 26)
Are all emergency release nuts working?
Are the nylon straps attached to the bed frame and all the support bars?
Are the nylon straps intact?
Are the plastic parts intact and without signs of wear?
Are all wires intact?
Do both bars slacken and tighten the sheet?
Does the timer activate when the button is pushed twice within 2 seconds?
Does the timer turn off after 90 seconds of idle time?
Is the control unit securely suspended?
Are all cables securely attached to the control unit?
Have the lids on the control units been closed properly and are the lids intact?
Are all loose cables off the floor?
Is the slide sheet fitted on top of the mattress and properly attached?
Is the turning sheet fitted in such a way that it runs over the bars?
Is the quick guide visible and located near the bed?
Is the VENDLET Standard manual available?
Have the caregivers been instructed on the use of VENDLET Standard and its functions?
Has the VENDLET Standard system been signed up for an annual service check?
Date:
Carried out by:
Serial no.:
Bed model:
Mattress model and dimensions:
Client:
Address:
Date of next service check:
If there are ticks in the column “No”, it must be assessed
whether VENDLET should be used until the matter is resolved.