VENCO VP-6ED, Инструкция по установке и эксплуатации

Страница: 14 / 48

6112
H200
11-13-89
7-10-98A
INST INSTRUCTIONS
VP/VC-6R
SUPERCEDES
TITLE DATE
SECTION
7. Installing Hoist Main Frame: See Dwg. 6113 Figure 7A & 7B
(FORD only)
A. Cut the shield next to the gas tank downward about 3" - 4" just behind the cross member,
forward of the rear axle. Bend the shield behind the cross member downward. Move the
rubber vibration control strap, on the left of the muffler bracket, to the right about 1-1/2".
Use a die grinder to cut 1-1/4" off the end of the upper and lower rods on the muffler
bracket. Hammer a push nut on the end of both rods (3/8" dia.). Set a shim over the cross
member rear rivets - 1 each side. Put a 2 x 4 across the truck frame to support the hoist
frame. The front bottom edge of the 2" x 2" x 44-3/4" mounting tube should be even with
the top rear edge of the truck frame cross member.
B. Slide the side mounting plates (1 each side) over the mounting tube (44-3/4" long). The
right side end of the mounting tube should be 4-1/2" from the outside of the frame. Place
the 1-1/2" x 1-1/2" X 2" long angles (1 each side) against the front of the mounting tube
and the top of the cross member. Mark the area where the angles will be welded to the
mounting tube. Remove the hoist frame and weld the two 1-1/2" x 1-1/2 x 2" long angles
to the cross tube. Set the hoist frame back on the truck frame as positioned previously.
Check the inside of the frame members for cables, wires, etc. before drilling through the
truck frame. To prevent damaging the gas tank, put a piece of steel between the cross
member and the gas tank before drilling through the cross member. Clamp the side
plates and 1-1/2" angles to the truck frame and cross member. Drill two 13/32" dia holes
through the truck frame on each side. Fasten the side plates with 3/8"-16 x 1" bolts, nuts
and lock washers (2 each side) to the truck frame. Drill 11/32" dia through the cross
member at the 1-1/2" angle holes. Use 5/16"-18 x 1" long bolts, nuts and lockwashers
to fasten the angles to the truck cross member. Weld the side plates to the 2" x 2"
mounting tube.
MANUFACTURING, INC.