MAN-X5L-ENG-01
1
Operation & Maintenance
Models: X5L02250, X5L03528, X5
READ THIS MANUAL BEFORE USING THESE
PRODUCTS
. This manual contains important
installation and operation information
OSHA and ASME B30 require
before placing into service and before each use.
section 4.0 INSPECTION AND TEST
WARNING
1. Only allow people, trained in safety and operation of this product, to operate the hoist.
2. Only operate a hoist if physically fit to do so.
3. After use, or in a non-operational mode the hoist should be secured against unauthorized use
4. When a “DO NOT OPERATE” sign is placed on the hoist, do not operate until the sign has been
removed by designated personnel.
5. Periodically, inspect the hoist thoroughly and replace worn or
damaged parts. (See 4.0 INSPECTION and TEST)
6. Before use ensure that attachment points and supporting structure are
adequate. If in doubt consult a qualified professional.
7. Always visually inspect the hoist for wear or damage
before each use
8. Always check that the load is seated in the saddle of the hook and the
hook latch is engaged.
9. Always pay attention to the load and surroundings
10. Always ensure that the operator and all other people
path of the load.
11. Do Not use a hoist which inspection indicates is worn or damaged.
12. Do not use if hook latch has been sprung, broken
13. Do not support the load on the tip of the hook.
14. Do Not place your hand inside the throat area of a hook.
15. Do Not use the hoist load chain as a sling.
16. Do not operate hoist if chain jumping, excessive noise, jamming, or
binding occurs.
17. Do not force a chain or hook into place by hammering.
18. Do not allow the load chain to run over a sharp edge.
19. Do Not allow anyone to stand on a suspended load
20. Do Not swing a suspended load.
21. Do Not use the hoist chain as an electric welding
22. Do Not leave a load suspended when hoist is unattended
23. Do Not operate if restricted in forming a straight line between hooks
24. Do Not operate with lever extension or with other than manual power
25. Do Not operate with a twisted, kinked, or damaged chain
26. Do Not operate a damaged or malfunctioning hoist
27. Do Not lift people or loads over people
28. Do Not lift more than WLL (Working Load Limit)
Model:
AMH
TM
NOTICE
:
1
ⓒ
2016 All Material Handling
Operation & Maintenance Manual
X5L07056, X5L14000 & X5L20000
READ THIS MANUAL BEFORE USING THESE
. This manual contains important safety,
installation and operation information
OSHA and ASME B30 require Inspection
and before each use.
(See
4.0 INSPECTION AND TEST in this manual)
To avoid serious
injury or death
:
Only allow people, trained in safety and operation of this product, to operate the hoist.
operational mode the hoist should be secured against unauthorized use
OPERATE” sign is placed on the hoist, do not operate until the sign has been
Periodically, inspect the hoist thoroughly and replace worn or
.0 INSPECTION and TEST)
nsure that attachment points and supporting structure are
qualified professional.
inspect the hoist for wear or damage by operator
load is seated in the saddle of the hook and the
and surroundings when operating.
and all other people are clear of the
use a hoist which inspection indicates is worn or damaged.
broken or missing.
place your hand inside the throat area of a hook.
Do not operate hoist if chain jumping, excessive noise, jamming, or
Do not force a chain or hook into place by hammering.
over a sharp edge.
allow anyone to stand on a suspended load.
welding ground.
unattended.
Do Not operate if restricted in forming a straight line between hooks
th other than manual power
Do Not operate with a twisted, kinked, or damaged chain
Do Not operate a damaged or malfunctioning hoist
Serial No.
X5
TM
