VENCO VP-6ED, Инструкция по установке и эксплуатации

Страница: 34 / 48

6142
H200
-
7-10-98
INST INSTRUCTIONS
VP/VC-6R
SUPERCEDES
TITLE DATE
SECTION
VC-6R See Figure 1 Below
CAUTION
If a distaance of more than 38" is exceeded between the centers of the rear axle and
rear hinge assembly, additional reinforcement of the truck frame will be required.
a. Mark the location for the rear hinge. This location should be immediately behind a truck
crossmember. The hole center of the rear pivot angle should not be more than 6" rearward
of the rear spring hanger.
b. See Figure 1, cut as shown a 90° slot in frame (both sides).
c. Position the angle iron frame of the rear hinge assembly in the truck frame cut outs. Make
sure the rear pivot angle assembly is properly positioned on the truck frame. Weld all around
truck frame, hinge assembly joint.
MANUFACTURING, INC.