VEMCO - VR2C Manual
9
Jul 2018
7
2.2
Connect VR2C to PC
2.2.1
Connecting a cable to the VR2C
Connect the 5 m cable supplied in the communication package (see section 2.2.2) to the VR2C by following
the steps below. This procedure is the same for any cable but we’re starting with the short cable to
familiarize you with the receiver and also to test the receiver. The pin-out of the connector is found in
section 1.3.2.
Line up the gap on the cable’s connector with the gap on the
VR2C’s external connector.
STEP 1
Grasp the cable at the connector and push straight in
until the gap between the two connectors is closed.
IMPORTANT:
Grip the
connector rather than
the cable. This
reduces damage-
causing strain on the
cable.
STEP 2
Slide the Locking Collar located on the external
cable (identified in photo) over the connector and
twist it clock-
wise until it stops. There shouldn’t be
a gap between the metal connector and the edge
of the Locking Collar.
STEP 3
