VEMCO – VR100 Receiver Operating Manual – Page 15
2.2.9 Take a GPS reading
A GPS reading is automatically stored in the VR100’s memory with each detection if the GPS receiver is
“locked” (see section 5.1). Manual GPS readings can be taken while in the Monitor screen (see section 4.2)
and stored to memory by pressing the LOG GPS button on the front panel of the receiver (see section
3.1.3).
2.2.10 View Used Memory Level
The Use line in the Event Log screen shows the percentage of log memory used in the VR100 receiver,
both numerically and graphically.
When 100 % of the log memory is full, the memory must be erased
before more events can be logged; old data are not deleted, but new data will not be stored until the
memory is erased. To prevent loss of data, upload the VR100’s memory to your PC before erasing
the memory.
To erase memory using the VR100, from the Main menu on the VR100:
1.
Select Config (right selection button).
2.
Press “5” on the keypad.
IMPORTANT
When the VR100 memory
is full, it must be erased
before more data can be
stored. Use the VR100HS
software to copy data to a
computer
before erasing
the VR100’s memory.
Event Log
Event Count: 42500
Use: 50 % ▊▊▊
Erase
09:01:07 ▬
GPS Status: 1 a
Monitor
Config
Press right selection
button to erase memory
Amount of
memory used
NOTE: Ensure that the GPS receiver has a position fix before manually logging GPS readings. If the
GPS receiver is not “locked” when the LOG GPS button is pressed, the request will be queued until a
GPS position fix is obtained.
