VEMCO – VR100 Receiver Operating Manual – Page 10
5.
Use the arrow buttons to select the type of continuous sensor transmitter to be monitored, either “Cont
1 Sensor” or “Cont 2 Sensor”.
6.
Press the right selection button for “Next”.
7.
Enter the serial number of the desired tag, or use the arrows to select it from the list, and select “Next”.
NOTE: The tag must be set up in the receiver before it can be monitored. See section 4.3.4.2 or
4.3.4.3 for how to set up a continuous sensor transmitter in the VR100 receiver.
8.
Review the summary screen to verify that the information is correct.
9.
Press the right selection button for “Accept”.
10.
Select the channel to be set up by either using the up/down arrows or pressing the corresponding
number on the keypad.
11.
Press the left selection button for “Set on” to turn this channel on. If you don’t want to turn the
channel on at this time, perform steps 10 and 11 at a future time.
2.2.3 Set up a channel to monitor a coded tag
A channel can be set up to monitor a large number of coded tags on one frequency. More detail is given in
section 4.3.1.2.
1.
Select Config (right selection button).
2.
Press “1” on the keypad.
3.
Select the desired channel number on the keypad, or use the arrow buttons to move through the list of
channels until the cursor is over the desired channel.
4.
Press the right selection button for “Configure”. The channel’s configuration is displayed in a
summary screen.
5.
Select “Edit” with the left selection button to change the channel’s configuration or “Accept” with the
right selection button to return to the channel screen.
6.
Use the up and down arrows to cycle through the four tag types until “Coded” is displayed and then
select “Next”.
7.
Enter the frequency (usually 69 or 180 kHz) on the key pad and select “Next”. NOTE: If you make
an error, keep pressing the first number until the cursor returns to the first digit place.
8.
Select the code map (see section 4.3.3) to be used on this channel by pressing the arrow buttons to
scroll through the list of code maps.
9.
Press the right selection button to select “Next”.
10.
Review the summary screen to verify that the information is correct.
11.
Press the right selection button for “Accept”.
12.
Verify that the cursor is over the channel you just set up. If it isn’t, use the up/down arrows until the
cursor is in position or press the corresponding number on the keypad.
13.
Press the left selection button for “Set on” to turn this channel on. If you don’t want to turn the
channel on at this time, perform steps 12 and 13 at a future time.
