VeEX VePal TX130M+, Руководство пользователя

Страница: 51 / 175

suite needs to be stopped before they are done, then simply press the Stop button, located in the actions pull down menu. The
status of each selected test can be seen in the Results tab.
Far-End Unit Controlled with Manual Mode Loop Up/Down Commands
If the far-end unit is not manually looped back, then it must first receive a loop up command from the control unit
before the RFC 2544 test suite can be started.
To loop up the far-end unit with the manual mode loop up/down commands, configure the control settings mode to
manual.
Enter the MAC and/or IP address of the far-end unit.
Send the loop up command by pressing 'Loop Up'
Once the far-end unit has been looped back, start the test by pressing the Start button. When the all of the selected test are
completed, the RFC 2544 test suite will stop automatically. Once all tests have been completed and there is no need to test
again, go back to the Control tab, and press the 'Loop Down' button. This will send a loop down command to the far-end unit to
remove the loopback that is in place.
Far-End Unit Controlled with Automatic Mode Loop Up/Down Commands
If the far-end unit is not manually looped back, then it must first receive a loop up command from the control unit
before the RFC 2544 test suite is started.
To loop up the far-end unit with the automatic mode loop up/down commands, configure the control settings mode
to automatic.
Enter the MAC and/or IP address of the far-end unit.
Press Start to automatically loop up the far-end unit
Start the RFC 2544 test, and loop down the far-end unit when all tests have been completed.
Go back to top Go back to ToC
8.2 RFC 2544 Results
The progress and current result of the RFC 2544 can be viewed as the test is in progress.
Results tab:
Navigate the respective sub-tabs (throughput, latency, frame loss, or burst) to view the results for each test. For the burst test
the results can be viewed in summary table format or test log format.
Go back to top Go back to ToC
8.2.1 Status and Events
The status of each test is displayed including a time stamped log of each test.
RFC 2544 Results - Status RFC 2544 Results - Events
_e-manual_D07-00-051P_RevD00