VeEX VePal TX130M+, Руководство пользователя

Страница: 109 / 175

16.1 V-SAM Setup
General (Page 1)
Profile:
Default, Save, Save as New
# of Services:
Select the number of services to run. Up to 8 services can be chosen for a 1 GE interface.
Configuration Test:
Enable or Disable the configuration test.
Configuration Test Step:
Specify min and max duration for the configuration test step.
Performance Test:
Enable or Disable the performance test.
Perf. Test Duration:
Selections are 15 min, 30 min, 1 hour 2 hours, 24 hours, and user defined. User defined enables the
user to specify min and max duration for the performance test.
General (Page 2)
CIR Test Config.:
Select Simple Test, Step Load Test, or Simple and Step.
Simple Test:
Starts the tests at the CIR.
Step Load Test:
Starts the test below the CIR and continues in steps until it reaches the CIR.
Simple and Step Load Test:
Step Load Test performs only if the Simple Validation test fails.
Stop test on Fail:
Enable or Disable
Step #:
Tap on the corresponding box to enter the percentage of CIR that the test will reach for each step.
V-SAM Setup (Page 1)
V-SAM Setup (Page 2) - Simple and
Step Load Test
V-SAM Services Summary
V-SAM Services Summary
Once setup parameters are completed, tapping the zoom function at the bottom right hand side of
the screen displays a summary of all service settings. A check next to the Service number indicates
that the test for the corresponding service is set to run. Tap on the box to remove the check and
cancel the test for that service.
Go back to top Go back to ToC
16.1.1 Header Settings
Please see 8.1 RFC 2544 Setup and follow the setup procedure to configure the Header Settings for V-SAM. Tapping the zoom
function on the bottom right hand side of the screen displays the Summary, MAC and RX Filter tabs which are also explained in
_e-manual_D07-00-051P_RevD00