VDL Futura FHD2 E6, Руководство по ремонту

Страница: 161 / 184

0
Futura FHD2/FMD2 E6
PAINT TREATMENT
1 - 5
Paint treatment
7
DD1020_01
1.3 REPAIRING THE LAYER OF ZINC
Repair
• Only use the products stated in the guidelines, because
only then can the paint system be properly repaired.
• Carefully follow the paint manufacturer’s instructions when
applying paint.
• After welding, also treat the back of welded objects as
described below.
• Observe the guidelines given below which meet the
requirements of NEN-EN-ISO 1461.
1. Cleaning
• Remove any loose flakes of zinc.
• If the surface to be treated cannot be lightly blasted,
clean it with a steel brush and/or coarse sandpaper.
• It the still intact layer of zinc 10 mm around the surface
to be treated cannot be lightly blasted, clean it with a
steel brush/coarse sandpaper.
• Use a Tack cloth to remove any dust from the area to
be treated.
• Degrease the surface to be treated and the surround-
ing area with a solution of, for example, paint thinner.
2. Applying zinc paint
• Primer to be used: Redox EP Multi Primer from
Sikkens or 622-Unibar Zinkrich from Baril Coatings.
• Apply a 2-component EP primer (enriched with zinc) to
the pre-treated surface in 2 or 3 layers in accordance
with the manufacturer's instructions.
The minimum thickness is 100 µm. The EP primer can
be applied with a brush or a roller.
3. Applying the topcoat
• Topcoat to be used: Redox PUR Finish from Sikkens.
• Apply the topcoat over the primer in accordance with
the manufacturer’s instructions. The minimum thick-
ness is 50 µm. Redox PUR Finish can be applied with
a brush or a roller.
• Apply an antichip coating to the entire treated area (see
7 - 2.2 Antichip coating (

2 - 2) ).
It is not permitted to treat galvanized
steel with a primer with an alkyd resin
base.