VDL Futura FHD2 E6, Руководство по ремонту

Страница: 27 / 184

0
Futura FHD2/FMD2 E6
SAFETY REGULATIONS
1 - 3
General information
1
DD1020_01
1.3 SAFETY REGULATIONS WHEN
CARRYING OUT WORK
– Always observe the instructions and regulations given in
the VDL Bus & Coach workshop documentation.
– Remain a safe distance from rotating and/or moving com-
ponents.
– Make sure there is good ventilation or extraction equip-
ment when carrying out work where vapours and/or gases
are released.
– Always protect the vehicle from rolling away by applying
the parking brake and, for example, placing chocks in front
of and behind the wheels.
– Always use hoisting sheers when working under the vehi-
cle.
– Be careful when working on tensioned springs, such as
those in spring brake cylinders, valves, etc. Accidentally
released springs may cause a serious injury. Small springs
and circlips may also cause injury when accidentally
released (wear goggles).
– The earth cable must always be removed from the battery
when carrying out work that does not require the vehicle to
have an electrical power source.
– In order to prevent people from starting the engine when
work is being carried out on the vehicle, always disconnect
the battery’s earth connection. Place a sign that reads “DO
NOT OPERATE” on the dashboard.
– Do not place tools or other materials on or near the batter-
ies. This could short-circuit the battery or may even cause
the battery to explode.
– Do not leave tools unattended on or in the vehicle.
– Always wear protective gloves when working on compo-
nents that must be heated.
Not observing the safety regulations and
warnings may place the health and safety
of the mechanic at risk.
It may also cause serious damage to the
vehicle or may even create a dangerous
situation.
To prevent damage to electrical
components, never disconnect the
battery terminal clamps whilst the engine
is running.
Turn off the contact switch and the main
switch before disconnecting the
connection between the battery terminal
and the negative pole. Wait at least 80
seconds after turning off the contact
switch before disconnecting the
connection between the battery terminal
clamp and the negative pole. If the
connection is disconnected too quickly,
the AdBlue lines may become blocked.