VDL Futura FHD2 E6, Руководство по ремонту

Страница: 164 / 184

0
Futura FHD2/FMD2 E6
PAINT TREATMENT
Anticorrosion/antichip coating
2 - 2
7
DD1020_01
2.2 ANTICHIP COATING
The underside of the vehicle is treated with an antichip coat-
ing during manufacture.
This coating should be demonstrably checked for damage
every year.
This coating must be replaced no later than every three
years. Damage to the antichip coating must be repaired as
quickly as possible.
2.2.1 PRODUCTS
It is possible for the antichip coating to be different depending
on the region in which the vehicle is used.
2.2.2 INSPECTING THE ANTICHIP COATING
1. Clean the underside of the vehicle (see 5 - 1.1 Cleaning
the vehicle (

1 - 2) ).
2. Check all the external components for damage and
check the attachment of the protective layers, such as
the antichip coating and the paint.
3. Thoroughly check the corners where dirt can collect and,
if necessary, remove any dirt.
4. Make sure the wheel arches and the surrounding areas
are clean.
5. Make sure the water drainage holes are not blocked.
6. The specified thickness on the underside of the chassis
and the plate modules after drying must be at least 650
µm (including the powder coating).
In other locations, the minimum thickness after drying is
300 µm.
Comment
Cracks may appear in time in the corners where the antichip
coating is applied.
Small cracks must be repaired. For larger cracks, it is neces-
sary to reapply the antichip coating.
Product When/where to use
Dinitrol UBC 4942 Regions with a temperature
below or above 22 °C.