vc999 593.767, Оригинальное руководство по эксплуатации

Страница: 65 / 96

Shrink Tunnel VC999 ST2/ST2 D
Operating messages and faults
2009-11-12
Art. no. 593.767 Page 65/96
Fault Possible cause Remedy
Water temperature or
water level fluctuate
strongly Automatic water supply is faulty due to a
soiled filter sieve Clean the filter sieve (see section "Clean-
ing the water supply line filter sieve".
Water supply does not
cut-off correctly, water
drains via the overflow Upper floating switch defective Replace the floating switch
Contact the VC999 Customer Service
Department
Drive or bearings or guide elements worn Conveyor belt too loud
Wire mesh conveyor belt defective
Check and replace if defective
Contact the VC999 Customer Service
Department
Photocell soiled Clean the photocell and the reflector
Incorrect setting Re-adjust the photocell
Machine does not start
up for incoming products
Photocell defective Replace the photocell
Contact the VC999 Customer Service
Department
Strip curtain not installed or defective Install the strip curtains or replace a de-
fective curtain
Fan defective Replace the fan
Contact the VC999 Customer Service
Department
Excessive steam emis-
sion
Only for VC999 ST2 D:
Steam supply line leaking Check steam supply line for leaks and
repair
Water pump defective Replace the water pump
Contact the VC999 Customer Service
Department
Water circuit leaking or blocked Contact the VC999 Customer Service
Department
Hot water cascade does
not cover the entire con-
veyor width
Water circuit furred up Decalcify the system
(see the section "Decalcification mode")