Vatech Pax-i PCH-2500, Руководство по установке

Страница: 11 / 200

PaX-i
(PCH-2500) Installation Manual
11
Notice to the Installers
Installation Site
1. PC monitors, emergency shutdown switches, and X-ray exposure switches
should be installed near the operator for emergency management.
2. Proper shielding of the room is essential: Since these requirements vary
depending on the country, it is the installer’s responsibility to verify that all
applicable radiation safety requirements are met.
3. This equipment should not be installed in the immediate vicinity of other
devices.
4. Do not install the equipment in an area that is exposed to strong
electromagnetic fields.
5. Do not install this system in an area where there is the risk of an explosion.
6. The electrical installation of this system shall comply with all local code
requirements for electro-medical systems:
IEC 60364-7-710
.
7. It is strongly recommended that a UPS be installed at the same time as the
equipment.
8. The equipment, PC, and all peripheral devices must be well-grounded.
Warnings Regarding X-Ray Radiation
1. Failure to install this equipment in an approved location may be dangerous
to the patient and operator.
2. Stationary radiation shielding must be installed to protect the operator from
radiation.
3. The X-Ray system may cause injury to the patient if improperly used. Obey
all federal and municipal standards regarding radiation safety.
4. When exposing the patient to the X-Ray, the operator must be behind a
protective wall or take other protective actions. The operator should remain
at least 2 m (7 feet) away from the X-Ray when pressing the exposure
switch and observe the patient and capture-progression.
5. Operators must provide protective clothing to the patient before X-Ray
capturing. Pregnant women must consult with a doctor prior to being
exposed to an X-Ray.