Vatech Pax-i PCH-2500, Руководство по установке

Страница: 88 / 200

PaX-i
(PCH-2500) Installation Manual
88
5 Installing the Equipment: Wall Mount
Drilling∙8∙locations∙on∙the∙floor∙and∙wall
1 . Put the alignment plate (Part No.39) aside
from the ground.
2. Drill the ground and wall holes of size 10 mm
x 30 mm (depth) using the concrete hammer
drill.
3.
Remove the debris and clean the holes using
the dust pump.
4.
Using the hammer, insert a Ficher strong
anchor into the hole.
Ficher strong
anchor
M8 x 30
Marking Points on the Wall
1. Move the equipment to the installation site as close as possible.
2. Adjust the distance between the wall and equipment by moving
it slightly, so that the wall bracket touches the wall.
3. Mark four anchor bolt locations on the wall.
Marker n/a
Drilling on the Wall
1. Drill the wall holes of size 10 mm x 30 mm (depth) using the
concrete hammer drill.
2. Remove the debris and clean the holes using the dust pump.
3. Using the hammer, insert a Ficher strong anchor into the hole
Ficher strong
anchor
M8 x 30
Hammer n/a
4. Using hammer, inserting the EHS tool into the inner bolt
EHS Plus
setting tool
EAW H 8X30
plus
Hammer n/a
Hammer
5. Using the hammer, insert an EHS tool into the
inner bolt.
EHS tool
EAW H
8x30
Marking Points on the Wall
1. Move the equipment to the installation site as close as possible.
2. Adjust the distance between the wall and equipment by moving
it slightly, so that the wall bracket touches the wall.
3. Mark four anchor bolt locations on the wall.
Marker n/a
Drilling on the Wall
1. Drill the wall holes of size 10 mm x 30 mm (depth) using the
concrete hammer drill.
2. Remove the debris and clean the holes using the dust pump.
3. Using the hammer, insert a Ficher strong anchor into the hole
Ficher strong
anchor
M8 x 30
Hammer n/a
4. Using hammer, inserting the EHS tool into the inner bolt
EHS Plus
setting tool
EAW H 8X30
plus
Hammer n/a
Hammer