Valcourt L48, Инструкция по установке и руководство пользователя

Страница: 72 / 84

Page 72 Installation Instructions and Owner’s Manual - L48
ENGLISH
MAINTENANCE AND SERVICE
Removing the Barrier Screen
Lift the barrier up approximately 1/4-in with
one hand under the lower barrier frame edge
to disengage the lower flange. Grasp the top
of the barrier and pull forward to disengage it.
Remove the barrier by pulling straight forward.
Removing the Glass Door Assembly
Locate the glass door tool (secured to the top
of the fireplace for shipping). Use the tool as a
lever to release the bottom of the glass door as
shown in
«Figure 113» .
Notice: The glass door is secured to the top
of the firebox with tabs that allow the glass
door to pivot outward at the bottom. The
bottom of the door frame engages into the
four bullet type retainers.
Pivot the glass door out until the bottom of the
door is about 6 to 8 inches from the firebox
face, then lift upward on the door assembly
to disengage the top of the door from the tab
retainers on top of the firebox.
CAUTION
The glass door is wide and heavy
and can be difficult to install or
remove by a single person. It is
recommended that two people
remove the glass door.
LIFT UP TO RELEASE
FROM TABS
TABS
1
2
FIREPLACE
FACE
PIVOT OUT
GLASS DOOR
ASSEMBLY
Figure 113
Wiring
If any of the original wire supplied with this unit
must be replaced, it must be replace with 18
GA. 150°C wire or its equivalent.
Replacing the Light Bulbs
Bulb Type: 120V 35W G 6.35mm base
CAUTION
Turn off all power to the fireplace
prior to changing bulbs or
servicing the controls.
1. Remove the barrier and the glass door
assemblies.
2. Lift the light access cover up and out of
the firebox. See «Figure 114»
3. Remove the bulb(s) to be replaced. See
«Figure 115» .
4. Wear gloves or use a clean cloth while
handling bulbs or bulb lifespan may be
decreased.
Figure 114
Figure 115