Valcourt L48, Инструкция по установке и руководство пользователя

Страница: 54 / 84

Page 54 Installation Instructions and Owner’s Manual - L48
ENGLISH
7. Remove the cover plate by simply lifting
up and out of the fireplace. This part will
not be reinstalled.
Figure 103
8. Remove the burner cover assembly. Grasp
the cover as shown in «Figure 104» and
pull upward to release, then set aside.
Note: the burner screen does not need
to be removed to complete installation.
Figure 104
9. Before you install the light kit, remove
the (2) # 10 x 1/2-inch screws that retain
the front angle support bracket shown
in
«Figure 105» . The front angle support
will not be reinstalled. The two removed
screws will be used in step 12.
Figure 105
10. To install the light kit assembly, first locate
the two stubbed in tan wires near the gas
line entry point to the right side of the
firebox. Remove two terminal protectors
shown in
«Figure 106» inset. Discard
protectors.
Figure 106
11. Install the light bracket assembly with the
wire terminal connections to the right side.
Plug up the two connectors as shown.
Figure 107
12. Move the light bracket assembly down
between the front ledge of the firebox
and the burner assembly. Line up the two
mounting holes in the light bracket with
the pilot holes located in the two small
brackets at the front of the firebox, then
install two 5/16-inch x ½-inch hex screws
to secure.
Figure 108