Vaderstad RAPID RDA S Series, Инструкция по эксплуатации

Страница: 12 / 122

Assembly instructions
12 Ver.2 01.11.2002
2 Assembly instructions
NOTE!
The drill is delivered completely assembled to the customer. The assembly instructions in
the following are intended to be used by assembly staff and service personnel at the dealership.
On delivery, the drill may be almost fully assembled depending on the method of transport etc.
Use the following instructions where necessary. The drill can also be delivered with extras not
covered by these instructions. If in any doubt, contact Väderstad-Verken AB or your dealer.
2.1 Lifting and unloading the drill
Use either pallet forks or lifting straps (not chains) when lifting the drill.
When lifting with pallet forks, lift from the front in the places indicated by the labels.
When lifting with lifting straps, attach the straps to the folded up wings in the places indicated by
the labels. Use lifting straps at least 6 m long.
NOTE! Never lift the machine in the indicated places if the wings are folded down.
Loaders and lifting equipment used to lift the drill should have sufficient margin to manage the
weight of the machine. For weight indications, see ”
7.5 Technical data” on page 120 . Lift down
the drill and then carry out the remaining unloading and assembly on a firm, level surface.
NOTE! Never walk under a suspended machine.
Lift out all the parts that have been packed behind the hopper. Also unpack the separate parts that
have been put in the hopper.
Figure 2.1 Figure 2.2