Vaderstad RAPID RDA S Series, Инструкция по эксплуатации

Страница: 20 / 122

Assembly instructions
20 Ver.2 01.11.2002
2.14 Fitting the platform
Figure 2.15
Install the outer end plates in the installation holes on the hopper.
Install the platform on the outer end plates. The angled corner (A) of the platform should be out-
side the outer end plate (B).
Install the guard rails and the ladder.
2.15 Fitting the scrapers
Figure 2.16
For transport reasons, some models may be delivered with the scrapers folded up. In such cases,
half of the fixing screws for the arm (B) are packed inside the hopper.
The distance between the scraper blade and the tyre should be at least 5 mm.
To check this: Let the drill rest on the discs, with the wheels a few centimetres over the ground.
Rotate the wheels and check that the scraper blades at no point come within 5 mm of the tyres.
NOTE!
If the scraper blade is not in the right lateral position after fitting, the fittings can be adjust-
ed with a suitable tool.
Make sure the fixing screws for the scraper mounting are properly tightened
B
A
B