7
Calibration
7.1
Checking lift and output levels
(only applies to TPF)
Figure 7.1
Settings
Setting the level for raising the machine when drilling
(LowLift) and setting the level for output start and output
stop.
A.
LowLift level
Maximum LowLift height is 79. The
set value is a percentage of the level for a fully raised
machine, which is 100.
B.
Level for output start
The level at which the seed
meter begins feeding out seed when the machine is
lowered into the sowing position. The set value is a
percentage of the LowLift height.
C.
Level for output stop
The level at which the seed
meter stops feeding out seed when you raise the
machine to the LowLift position. The set value is a
percentage of the LowLift height.
D.
Lift height
The machine’s momentary height.
E.
Lowering stop
(sowing position).
The position for lowering stop
(sowing
position) should not be changed when output
start, output stop and LowLift are set! The
setting is made during basic machine setup.
(The drilling depth is set individually for each
row unit.)
Adjustment
1. Press the button for the function to be set in the field
with the height scale. The corresponding function
button can also be pressed on the VT.
2. Raise or lower the drill unit to the desired position
using the hydraulic lever. The indicator arrow (F)
follows the drill unit’s movement along the height
scale.
3. Confirm the value between each setting.
or
can never be higher than
or
lower than
. Nor can they overlap.
7.2
Calibration of the amount of
delivered seed
Go to calibration by selecting Settings/Seed.
7.2.1
Calibration menu
Figure 7.2
Display
A. Air pressure
B. Number of skips
C. Number of doubles
D. Output quality
E. Amount of seed
F. Number of seeds/ha or seed spacing (depending on
calibration method).
A
D
C
B
F
E
H
I
I
G
K
J
L
16
903075-en-gb; 07.06.2017
