V2 HYPERFOR 4000-I, Руководство пользователя

Страница: 42 / 132

ENGLISH
- 40 -
3.6 - MOTOR OVERRIDING SYSTEM
In the absence of power, the gate can be released
by operating on the motor:
1. Open the rear hatch
2.
Screw anti-clockwise (left thread) the ring nut
K
using the supplied 19” wrench until the pinion
is released
To restart the automation proceed as follows:
1. Screw clockwise (left thread) the ring nut K up
to the limit given by screw L
2. Close the rear hatch
3.7 - INSTALLATION LAYOUT
L
K
1 3 E
5
4
A
B
F
D
2
C
LENGTH OF THE CABLE < 10 metres from 10 to 20 metres from 20 to 30 metres
Power supply 230V 3G x 1,5 mm 2 3G x 1,5 mm 2 3G x 2,5 mm 2
Photocells (TX) 2 x 0,5 mm
2
2 x 0,5 mm
2
2 x 0,5 mm
2
Key switch 4 x 0,5 mm 2 4 x 0,5 mm 2 4 x 0,5 mm 2
Photocells (RX) 2 x 0,5 mm
2
2 x 0,5 mm
2
2 x 0,5 mm
2
Flashing light 2 x 1,5 mm 2 2 x 1,5 mm 2 2 x 1,5 mm 2
Antenna (integrated into the flashing light) RG174 RG174 RG174
A
B
C
D
E
F
1
2
3
4
5
Key switch
Pillar photocells
Pillar-mounted digital radio switch
Safety edges
WES-ADI module (via radio management of edges)
WES sensors Motor
Transmitter
Receiving module
Photocells
Flashing light
COMPONENTS ADDITIONAL ACCESSORIES