UV Pure Technologies Crossfire Technology Hallett 1000NC, Инструкция по эксплуатации

Страница: 30 / 52

Hallett Instruction Manual
Released on 8-Aug-19
– GH2B
Page 30 UV Pure Technologies Inc. © 2019
UV chamber.
Step 1: Shutdown and unplug the unit then wait 5 minutes before opening the
UV chamber to allow the lamps to cool. The lamps heat up after continuous
use and can burn your skin if touched.
Figure 7.2
Step 2: See Figure 7.2. Open the UV Chamber by undoing the over-the-
center latch (may be more than 1). Note where the latch wire engages the
extrusion feature
– it must be re-latched in same manner.
Step 3:
Slowly swing the door completely to the left to reveal the two UV
lamps installed in the front half of the UV chamber. Note that the quartz
sleeve can be easily inspected.
Step 4: To close the UV chamber, slowly swing the door back towards the
back half of the UV chamber. Close all over-the-center latches ensuring the
wire correctly grabs the extrusion feature.
Step 5: Plug the unit in again.
Replacing and Cleaning UV Lamps
The Hallett contains two ultraviolet (UV) lamps that emit high-intensity UV
light in the germicidal range, providing effective disinfection of the water
flowing through the unit. The lamps in the unit will decay over time and they