UV Pure Technologies Crossfire Technology Hallett 1000NC, Инструкция по эксплуатации

Страница: 37 / 52

Hallett Instruction Manual
Released on 8-Aug-19
– GH2B
Page 37 UV Pure Technologies Inc. © 2019
free from the wire bundle.
Caution: Do not damage the sealing surfaces of the manifolds or the shaft
adapter for the wiper - handle these parts with care to prevent water leaks.
The wiper assembly must also be handled with care to prevent damage to
cleaning edges.
The wiper blades are sharp, handle them with care.
THERMISTOR
THERMISTOR
MOTOR
MOTOR
REMOVE WIPER ASSY. BY
ROTATING IT COUNTER-
CLOCKWISE AS YOU LIFT
PURGE VALVE
PURGE VALVE
WIPER POSITIONER (C)
WIPER POSITIONER (NO)
WIRES
Figure 7.6
Step 10: Remove the retaining ring (E-ring) holding the wiper shaft.
Step 11: Use the
7/16” (11mm) wrench or nut driver to remove the four nuts
of the top manifold in an alternating pattern (top left, bottom right, bottom left,
then top right). The bottom manifold does not require removal to clean the
quartz sleeve, so leave it in place. This will support the quartz sleeve during
cleaning and simplify the overall process.
Step 12: Press down on the wiper shaft and remove the top manifold (Figure
7.6) by lifting it straight up to disengage the wiper shaft. The shaft adapter
should remain on the top of the wiper shaft. Note the orientation of the slot to
the wiper blades
– the slot is aligned to the wiper blades.
Step 13: Remove the wiper assembly by carefully lifting it up and out of the
quartz sleeve. Rotating it counter-clockwise as you lift will help. Prevent the
shaft adapter from falling off the wiper assembly. Note that the shaft adapter
sits on the top end of the wiper shaft - the top end of the shaft has a hole, the
bottom end of the shaft does not.