urmet domus 1068/005, Руководство пользователя

Страница: 19 / 52

DS1068-020B
19
LBT20769
3 SYSTEM ACTIVATION FAILURE
This chapter describes the causes that prevent the activation of the alarm system, indicating any remedies to be taken.
An EN50131 compliant intrusion alarm system cannot be set by the User if certain blocking conditions are present.
There are also conditions that can be inhibited which may be overridden and bypassed by means of specific manual commands
imparted by the User or by the Installer.
The following describes both blocking conditions and conditions that can inhibited.
3.1 BLOCKING CONDITIONS
Conditions that always automatically prevent setting (regardless of the control device that requested activation).
The conditions that block the system are:

Open and non-excludable instantaneous intrusion input

Open and non-excludable tamper input

Open and non-excludable pre-alarm input

Open and non-excludable detector failure input

Open and non-excludable siren failure input

Unbalanced and non-excludable balanced or double balanced input (any customisation)
Input conditions only prevent the setting of the zones associated with them.
The conditions that prevent the setting of any zone are the following:

Bus failure

No communication with a wired device or a communicator or lack of radio supervision

Control panel tamper, radio device or wired device

24-hour inputs (open) (control panel SAB or wired expansion)

Jamming on radio module, radio interface or GSM/GPRS module

Control panel battery failure, radio device

+SR failure

Control panel power supply failure

Bus power supply voltage failure

+V1 failure

+V2 failure

Bus device failure

Loss of mains failure

PSTN module fault (available only with 1068/005 control panel)

GSM /GPRS fault

IP interface fault
3.2 CONDITIONS THAT CAN BE INHIBITED
The conditions that can be inhibited may be overridden and bypassed by means of specific manual commands imparted by the User
or by the Installer.
3.2.1 Conditions that can be inhibited on inputs
The input conditions apply to inputs associated with at least one of the zones for which activation is required.
The conditions requiring inhibition are as follows:

Open and excludable instantaneous intrusion input

Open and excludable tamper input

Open and excludable pre-alarm input

Open and excludable Detector failure input

Open and excludable Siren failure input

Unbalanced and excludable balanced or double balanced input (any customisation )
Inhibitions can be confirmed by any user.