r
oom
sensor
The room sensor only needs to be installed in zones
setup as
Stand Alone
, with
Heating Mode
setup as
O Indoor comp.
.
Placement of room sensor
Refer to the installation preparation guidelines (
see
section 4.2 Prepare for installation
), and use the
following guidelines when positioning the room sensors:
1. Select an indoor wall and a position 1.3 m to 1.5 m
above the floor.
2. Ensure that the room sensor is away from direct
solar radiation.
3. Ensure that the room sensor will not be heated
through the wall by sunshine.
4. Ensure that the room sensor is away from any
source of heat, for example television set, electronic
equipment, fireplace, spotlights, and so on.
5. Ensure that the room sensor is away from any
source of humidity and water splashes (IP20).
1.3–1.5 m
Label room sensor
Label the room sensors, where suitable, with the zone
numbers they are to control, for example, #02, #03.
Attach room sensor to the wall
The illustration below shows room sensor mounting hole
positions and how to attach it to the wall using screws
and wall plugs.
60 mm
EN
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
1 9
U P O N O R S M AT R I X M O V E P R O · I N S TA L L AT I O N A N D O P E R AT I O N M A N UA L
