35
Problems
Reason
Solutions
1
2
3
4
The first layer is not sticking correctly
Printed model / layered fault
A stripe of part fail to print
Abnormal LCD performance under
the show logo function: no display
-
ing, flickering or different displaying
on left/right side
The calibration for platform initial point is not in
correct position
Follow z-axis calibration procedure and calibrate
again.
Use provided sandpaper to roughen the surface
of the build platform and clean up.
Follow the guidance to re-insert or install the
LCD cable.
Follow the guidance to replace the LCD panel.
Return to the factory for repair.
1. Replace with a new resin tank;
2. Remove the resin tank, clean the LCD panel and the bottom
of the resin tank film; wipe them with alcohol and then with a
dry paper towel. (Note: touch ONLY the glass part of the screen,
the area covered with black tape should not be touched);
3. Increase cool down time.
Use provided sandpaper to roughen the surface of the build
platform and clean up.
Build platform surface is too smooth, printed
model falls into the resin tank
The suction force between the resin tank film and
models is too strong
A row of lights are damaged on the LED light
board
The LCD cable is not inserted properly; damaged
LCD cable
The screen is damaged
Insufficient adhesion between printed layers
Use provided sandpaper to roughen the surface of
the build platform and clean up.
