29
This function is used only when the
printed model is smaller than the
theoretical value along the Z axis
direction. The adjustment value is equal
to the theoretical value minus the actual
value.
Once the resin film is removed, the resin tank is clean and ready for the next print job.
Show Logo:
Show Logo is used to verify if the LCD screen is functional. Before using this function,
remove the build platform and resin tank, then click “Show Logo” Button to show the UNIZ logo on
the LCD screen to test communication and LCD screen.
Reset Z-Axis Zero Position:
Reset Z-axis Zero Position is used to re calibrate the vertical motor.
Please remove the resin tank and wipe clean the build platform before using this function. On
the popup box, click “Yes” Button, then push the build platform down manually to touch the LCD
screen. Then click “Yes” again, and the build platform will rise back up.
This function is used if there are issues relating to the initial distance between the build platform
and the screen. This may help with failed prints or adhesion issues.
Z-axis Compensation:
Enter a value to set a compensation value for the z-axis. This will shorten
the z-axis height from the mechanical calibrated value.
1. Install an empty resin tank and, attach resin sensor to the tank;
2. Calibrate Tank Empty Level: Clicking “Read” and “Cal” button until “Tank Reading” is
Resin Tank Level Cal
Calibration of Resin Level Sensor:
Click
“Calibration of Resin Level Sensor”
button to open the dialogue box.
TIPS:
It is recommended to check the bottom of resin tank before every print job. When there is
debris either floating in the resin or sticking to the bottom of vat, it can damage the LCD.
NOTE: DO NOT remove the resin tank during cleaning exposure. After exposure, however,
you may lift the resin tank to remove the cured resin film.
