Universal Laser Systems SuperSpeed-660, Руководство по безопасности, установке, эксплуатации и базовому обслуживанию

Страница: 82 / 84

ACCESSORIES
Section 6-14
•
Place the bracket on the table (1). Insert the thumbscrews and washers (2) into the screw holes but
do not tighten down completely. Leave the thumbscrews loose enough so that the bracket can slide.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
1
2
3
4
5
6
7
8
9
10
11
12
2
1
1
•
Place the Rotary Fixture on a flat surface. Using an Allen wrench, attach the two socket head
shoulder screws (1) to the side of the base plate.
•
Place the Rotary Fixture on top of the bracket so that its pivot bolts set into the forks in the bracket.
Gently push the fixture (1) flat up against the top ruler.
NOW , tighten down the thumbscrews (2).
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
1
2
3
4
5
6
7
8
9
10
11
12
2
1
WARNING
TURN THE LASER SYSTEM OFF BEFORE
CONNECTING OR DISCONNECTING
THE ROTARY FIXTURE
•
With the power to the system still OFF , connect the 9-pin Rotary Fixture control cable to the
receptacle on the laser engraving system (1).
1
2
3
4
5
6
7
8
9
10
11
12
READY
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
•
Before loading the glass into the fixture, measure the diameter of the glass in the
area where the engraving is to be located by using a caliper or similar measuring
device. Either remember this number or write it down.
•
Place the open end of the glass on the right side of the Rotary Fixture. Lift the
lever (1) on the adjustable end of the fixture and slide it up against the base of
the glass so the glass rests firmly centered inside of the inverted cone. Push the
adjustable end of the fixture (2) to the right, firmly against the bottom of the glass. Do not to apply too
much pressure, especially with glass. You only need enough pressure to prevent the object from
slipping on the cone while it rotates. Lower the lever on the end of the fixture to lock it in place.
1