Universal Laser Systems SuperSpeed-660, Руководство по безопасности, установке, эксплуатации и базовому обслуживанию

Страница: 16 / 84

INSTALLATION
Section 2-4
6. Locate the cavity where the cables reside. Gently
pull the cables upwards and rest them on top of the
gray-colored plate as the diagram indicates.
7. Close and re-latch the rear cover.
8. Remove any packing materials or accessories from
inside the laser system.
9. Using strong shipping tape or rope, tape the front
door closed so that it does not open up when you
tilt it.
10. Remove the eight (8) screws, flat washers, and lock
washers that attach the cart stand to the laser system
from the bottom.
11. Lift the laser system straight up, clearing the cart stand.
12. Place the laser system face down on the dolly and roll
it through the doorway. If you do not have a dolly, you
will need to carry it through.
13. After you get the laser system and the cart stand
through the door, carefully line up the laser system and
place it back on top of the cart stand.
Be careful not
to pinch your fingers .
14. Attach your screws, flat washers, and lock washers.
Gently push the cables back into the cavity, re-connect
the three power supply connectors, re-attach the cover
plate, close the rear cover, and push down on the
latches until they “click”.
Leveling the System
Move the laser system to the desired operating
location. If the floor underneath the laser system, at
this location, is uneven, the casters must be adjusted.
Uneven flooring can cause mechanical problems
with the operation of the motion system, which can
seriously affect engraving or cutting quality.
1
2
3
4
5
1. Place a bubble level across the front (2) and rear
legs (3). Adjust the caster height using the
adjustment screw (4) until both the rear part and
the front part of the legs are level with respect to
each other. Once the system is level, secure all
casters by tightening the nut (5) up against the cart
leg.
2. Open the top door and remove the rubber band
that is holding the arm in place.
3. If you haven’t already done so, remove any remaining packing materials, accessories or any other
items that may be located inside the cabinet or on top of the engraving table.
4. Gain access to the rear of the laser system to install the laser cartridge(s).