Universal Laser Systems SuperSpeed-660, Руководство по безопасности, установке, эксплуатации и базовому обслуживанию

Страница: 21 / 84

Section 3
System Operation
From the control panel menus and buttons to focusing, loading and unloading materials, this section
covers the actual laser engraving and cutting process. If you have done so already, power ON your
computer and let it boot up completely
BEFORE powering ON the laser system otherwise your laser
system can “lock up” when attempting to run the first file and the only way to clear this error is to power
the system OFF and then ON again. You do not need to turn on your exhaust system at this time.
The Control Panel
The control panel on the laser
system provides easy access to
all of the controls necessary for
cutting and engraving operations.
When the laser system has finished initializing and homing, and if all the doors are closed, the green light,
on the control panel will be illuminated and the display will indicate READY.
The RED LED and GREEN LED (Light Emitting Diode) will act differently depending on the current state
of the laser system. Please refer to the chart below.
Red LED
CONDITION REASON
ON The system is initializing
The system is firing the beam in the Alignment Mode
OFF The system has finished initializing and is ready to receive a file
The top, front, or laser cover door is closed
FLASHING The top, front, or laser cover door is open
Green LED
CONDITION REASON
ON The top, front, and laser cover doors are closed and the system is ready to receive
a file
The system has finished processing a file and has returned to the home position
The system has been paused while running a file
OFF The top, front, or laser cover door is open
The laser system is firing the beam in the Alignment Mode
FLASHING The system is running
START
: Begins laser processing of the current file displayed in the “FILE DISPLAY” menu. If
any of the doors are open when you press this button, the motion system will start to move as
if it is processing the file, however, the CO2 laser beam is disabled and the red diode pointer will be
enabled to simulate the laser process.