Universal Laser Systems SuperSpeed-660, Руководство по безопасности, установке, эксплуатации и базовому обслуживанию

Страница: 47 / 84

MATERIAL SETTINGS GUIDE
Section 5-3
NOTE
When engraving very small objects, top speed cannot be achieved because acceleration and
deceleration of the motion system requires time and distance. The laser system will automatically adjust
itself to a maximum engraving speed that it can achieve due to the size and position of the graphic. This
is why you might notice that there might be no difference in engraving time on certain graphics whether
you choose 100% speed or less.
The following materials were tested with the laser system set at an Image density of 5 and in Single
Beam mode using one laser (except where noted otherwise). The following pages will fully describe the
results of these tests and will offer helpful hints when choosing materials, setting parameters, and using
different techniques to provide the best laser cutting and engraving results.
If your system is equipped with two lasers, total the power of the two lasers and
refer to the charts. For example, if you have two 30-watt lasers, refer to the
settings of a single 60-watt laser. If the total wattage is more that the charts
show, then refer to the setting of one laser and either reduce the power setting in
half or double the speed (if speed is 50% or less). If you are using a SuperSpeed,
and running in Dual Beam mode, use the settings of the wattage of one laser.
Please use these settings as a guideline or starting point, in most cases these
settings should work out well, but sometimes may have to be adjusted to produce
desirable results.
ACRYLIC - CAST AND EXTRUDED
ACRYLIC – MIRRORED
ALUMINUM – ANODIZED
BRASS – PAINTED
CORK
CORIAN / AVONITE / FOUNTAINHEAD
DELRIN (SEAL PRESS)
GLASS / CRYSTAL
LEATHER
MARBLE
MAT BOARD
MELAMINE
PLASTIC – MICROSURFACED
RUBBER STAMPS
VINYL – SIGN (3 MIL)
WOOD / WOOD INLAY