Universal Laser Systems SuperSpeed-660, Руководство по безопасности, установке, эксплуатации и базовому обслуживанию

Страница: 54 / 84

MATERIAL SETTINGS GUIDE
Section 5-10
CORIAN / AVONITE / FOUNTAINHEAD
RASTER ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
25 100 44 500 1 .005”
30 100 53 500 1 .005”
35 100 61 500 1 .005”
40 100 70 500 1 .005”
45 100 79 500 1 .005”
50 100 88 500 1 .005”
55 100 95 500 1 .005”
60 100 100 500 1 .005”
DEEP RASTER ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
25 100 13 1000 1 .015”
30 100 15 1000 1 .015”
35 100 18 1000 1 .015”
40 100 20 1000 1 .015”
45 100 23 1000 1 .015”
50 100 26 1000 1 .015”
55 100 28 1000 1 .015”
60 100 30 1000 1 .015”
VECTOR ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
25 60 4.0 1000 1 .010”
30 50 4.0 1000 1 .010”
35 43 4.0 1000 1 .010”
40 38 4.0 1000 1 .010”
45 34 4.0 1000 1 .010”
50 30 4.0 1000 1 .010”
55 27 4.0 1000 1 .015”
60 25 4.0 1000 1 .015”
COMMENTS
If paint filling, mask the material first, then engrave through the masking. In this way, when ready to paint
fill, the material is already masked. Spray painting seems to be the easiest. Use the paint sparingly.
Excess paint can accumulate on the edges of the engraving, which will make mask removal difficult and
leave unsightly ridges. It is best to apply several lighter coats than one heavy coat of paint. Remove the
masking after the paint has dried.
ENGRAVING THIS MATERIAL PRODUCES ABRASIVE PARTICLES . Clean the laser
system more frequently to reduce wear and tear on the motion system components and
optics. Damage to the laser system from inadequate or insufficient maintenance
ARE
NOT covered under warranty.