Universal Laser Systems SuperSpeed-660, Руководство по безопасности, установке, эксплуатации и базовому обслуживанию

Страница: 56 / 84

MATERIAL SETTINGS GUIDE
Section 5-12
DELRIN
RASTER ENGRAVING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
25 100 22 500 1 .015”
30 100 26 500 1 .015”
35 100 30 500 1 .015”
40 100 35 500 1 .015”
45 100 39 500 1 .015”
50 100 44 500 1 .015”
55 100 48 500 1 .015”
60 100 52 500 1 .015”
VECTOR CUTTING
LASER WATTAGE POWER SPEED PPI PASS DEPTH
25 75 2.0 200 1 .060”
30 75 2.4 200 1 .060”
35 75 2.8 200 1 .060”
40 75 3.2 200 1 .060”
45 75 3.6 200 1 .060”
50 75 4.0 200 1 .060”
55 75 4.4 200 1 .060”
60 75 4.8 200 1 .060”
COMMENTS
The laser system can be used to make dies for
seal presses. It can engrave and cut out a
typical Notary Seal in less than 5 minutes.
Create the male with a white graphic and a black
background. Mirror the image and invert it by
making the background white and the graphic
black. Add a .010 inch black outline to the
graphic portion of the female side. This will give
the greater clearance to the female side to
prevent the paper from piercing through when
the male side of the seal presses into the female
side. Once the seal is made and fastened to the
press, make several impressions onto 400-grit sandpaper to smoothen out the edges of the plastic. Make
sure you turn the sandpaper over to get both sides of the seal.
MALE FEMALE
LASER CUTTING THIS MATERIAL CAN CAUSE FLAMING.
Use caution when
attempting to cut this material. Make sure that the flame does not come in contact with
any part of the laser system.
NEVER leave the machine unattended while processing
any material. Damages caused by processing any material ARE NOT covered under
warranty.