Sprite Installation and Operator’s Manual
REV D1
Page 24 of 36
12.2 Replacing a Blown Fuse
Use the following procedure and the figure below to replace the fuse in the SPRITE.
12.2.1 Toggle the POWER switch to O (OFF).
12.2.2 Remove the ticket stock and, if installed, remove the optional lockable ticket box to improve access to the fuse
holder.
12.2.3 Disconnect the power cord, remove the fuse holder, and check the fuse.
12.2.4 If the fuse is bad, replace it with a fuse of the same rating (see below).
CAUTION
To prevent the risk of fire, replace only with the same type and rating of fuse.
12.2.5 Fuse specifications:
110 to 120 VAC 2 Amps
or
210 to 250 VAC 2 Amps
12.2.6 Re-install the fuse holder, power cord, and optional lockable ticket box (if applicable).
12.2.7 Toggle the POWER switch to I (ON) and re-install the ticket stock. Refer to Loading Ticket Stock Section for
details.
