Page 19 of 36
REV D1
Sprite Installation and Operator’s Manual
9.0
Operating Under a CRS or Airline Host
Before attempting to go Online with the host, the Unit should be powered on, set up, and aligned using the previous
procedures. Then continue with the following procedure:
9.0.1
Observe the control panel LCD. The LCD must display “Online Ready” or a customized Online status message:
9.0.2
If the Unit is not Online, press the
ONLINE/ENTER
push-button.
9.0.3
Send test ticketing data to the Unit.
9.0.4
Observe the control panel for an indication that the Unit is receiving data. The ONLINE LED indicator will flash
when data from the host is being received by the Unit.
9.0.5
Verify that a test ticket is printed after the host data transmission is complete and that the test ticket is printed
correctly. If the ticket is correct, the Unit is Online and ready to use.
9.0.6
If no ticket was printed or the ticket was not printed correctly, make sure the host data communications cable is
secure and is connected to COMM 1 (DB25F Serial I/O Port). Refer to the Installation Section for location
information. If there is still a problem, refer to Troubleshooting Section for help.
10.0
Clearing Stock Jams
To remove a ticket stock jam, use the following procedure:
10.0.1 Note the location of the jam indicated on the LCD and refer to the figure below to locate the corresponding area
where the jam occurred.
O n l i n e
R e a d y