Sprite Installation and Operator’s Manual
REV D1
Page 16 of 36
8.0
Basic Unit Operation and Setup
This section describes SPRITE power-on and off, initialization, ticket stock setup and loading, and explains operation of
the control panel push-buttons, Light Emitting Diode (LED) indicators, and Liquid Crystal Display (LCD). Information
is also provided on where to find instructions for operating the Offline Menu and printing sample ATB coupons.
8.1 Initial Setup
The Unit has been configured at the factory to meet each customer's requirements. Use the following procedures to power-
on the Unit, load ticket stock, and operate the Unit's controls. If any difficulties are experienced with any of these
procedures, please refer to the Troubleshooting Section for help.
CAUTION
To prevent damage, immediately toggle the power switch to the 0 (OFF) position if the
SPRITE does not indicate that initialization is in progress within 5 seconds after power is
applied. Initialization is indicated when the control panel LCD displays text immediately after
the power switch is toggled to the I (ON) position.
If power-on was aborted, wait 10 seconds before toggling the power switch back to the | (ON)
position.
If the LCD still does not display text within 5 seconds, immediately toggle the switch to the 0
(OFF) position (refer to Troubleshooting Section) for help.
Powering ON and OFF
8.1.1
To power-up the Unit, locate the black power switch on the back panel, next to the fuse holder and line input
connector, and toggle it to the I (ON) position.
