Page 9 of 36
REV D1
Sprite Installation and Operator’s Manual
4.0
Installation
4.1 Unpacking
Inspect the shipping container for evidence of in-transit
damage, such as being dropped, crushed, or punctured. If
damage is evident, contact the carrier directly to specify the
nature and extent of damage. If the container is free of damage,
remove the Unit by opening the top side and pulling the Unit
(secured with packing foam pieces) from the container.
Remove the foam and the plastic bag/cover from the Unit.
The
keys are in the accessory kit
.
Retain original shipping carton and foam for future use
.
Accessory Kit
After the Unit has been removed from the shipping container,
locate the Accessory Kit. The Accessory Kit consists of the
enclosure door keys, power cord, Installation and Operator's
Manual or Product CD, Operator’s disk(s), and some sample
stock for testing. The exact contents of the kit are subject to
change without notice and vary for each customer.
4.2 Location and Set-up
Choose a location that provides at least 1-inch of open space
between surfaces adjacent to the Unit and its sides, front, and
top to allow proper ventilation. At least 9 inches of space is
required behind the Unit for cabling, airflow, and one ticket box
(Bin A or Bin B). If two ticket boxes are used (Bins A and B),
at least 18 inches of space is required. The power cord supplied
with the Unit is 10 feet long.
You should position the Unit so you have access to the door on
the right side of the enclosure (
when viewed from the back
;
as
shown
), which must have room to swing open 90° to perform
routine maintenance.
Do not install the Unit where it will be exposed to direct
sunlight. Sunlight may affect the optical sensors resulting
in stock loading difficulties.
In particular do not allow the bin inputs to be exposed to
direct Sunlight because it will disable the Units ability to
detect stock when inserted. The Locked Ticket Box can be
used to shield the bin input sensors from light sources.
Direct sunlight can also affect the readability of the front
panel display.
The Unit is intended for indoor use only. Place the Unit on
a firm solid surface. If placed on an unsteady surface, it
may fall and become damaged.
To protect the Unit from overheating, do not block
openings on the enclosure. Do not place the Unit on or
near a heat source, such as a radiator or heat register.
