Unify Gigaset M2 plus professional, Руководство по обслуживанию

Страница: 15 / 61

SHB_PNG07.fm
A31003-G2100-S100-2-7620, 03/2014
PNG Configuration for Gigaset M2
plus and M2 Ex professional, Service Manual
15
PNG Configuration
Alarm Configuration
7.2.1 General Settings
The "General Settings" menu item contains the following parameters:
7.2.1.1 Alarm Number Basis
Enter the alarm destination here (maximum 32-digit number). This alarm destination is config-
ured here as a destination number for all alarm types. When an alarm is triggered, the alarm
call is signalled at this configured alarm destination.
If you want certain alarms, suchas, the non movement alarm, to be signalled at another alarm
destination, you can change the alarm destination later in the relevant alarm type’s submenu.
The "PNEZ Basis" parameter is automatically calculated and configured when you define the
"Alarm Number Basis". "PNEZ Basis" is the base number that is used for communication be-
tween PNEZ and PNG-S. See also Section 7.2.1.2, “PNEZ Basis (Number Configured)” and
Section 7.2.1.3, “PNEZ Basis (Number Deleted)”.
Please note: changing and saving "Alarm Number Basis" always affects all dependent config-
urations. Dependent configurations are the following:
●
All alarm destinations of various alarm types
●
"PNEZ Basis" and the control ports that are dependent on it
Please note: you must first define the "Alarm Number Basis", then make individual changes to
the alarm destinations of the various alarm types. Then, if necessary, you can configure the in-
dividual "PNEZ Basis" and control ports.
Parameter Parameter input
for startup See section:
Alarm Number Basis required Section 7.2.1.1, “Alarm Number Basis”
PNEZ Basis adjust to PNEZ if neces-
sary Section 7.2.1.2, “PNEZ Basis (Number Con-
figured)”
Section 7.2.1.3, “PNEZ Basis (Number Delet-
ed)”
Repeat alarm call optional Section 7.2.1.4, “Repeat alarm call”
Repeat Alarm Time optional Section 7.2.1.5, “Repeat Alarm Time [sec]”
Transport Time optional Section 7.2.1.6, “Transport Time [sec]”
Signal Off - manual optional Section 7.2.1.7, “Signal Off - manual”
Signal Off - autom. optional Section 7.2.1.8, “Signal Off - autom.”
Autom. alarms OFF optional Section 7.2.1.9, “Autom. alarms OFF”
Table 7-2 Parameter overview