Unicorn Digital Timepiece, Руководство пользователя

Страница: 73 / 101

D I G I T A L T I M E P I E C E & P E R F O R M E R
73
Setting up FreeMIDI
1 Create a FreeMIDI Device for the SY-88 card,
and set the Machine ID to match the SY-88’s
Machine ID.
2 Be sure the Digital Timepiece is properly
configured in FreeMIDI Setup as described in the
installation chapter.
Figure 9-6: This diagram displays a DA-88/SY-88 card connected to
cable 7 of an MTP AV. The Digital Timepiece is connected to cable 2.
The FreeMIDI Device Specification window for the DA-88/SY-88
displays FreeMIDI’s default settings, except for the Device ID, which
has been changed to 16 to match the SY-88’s Machine ID as config-
ured by the DIP switches on the card itself.
Disabling MMC parsing in the MTP AV
If you are using a MIDI Timepiece AV, you will
need to disable MMC parsing in it so that it does
not “swallow” MMC commands intended for the
SY-88 card:
1 Launch ClockWorks.
2 Select the MTP AV in the Device List window.
3 Open the Device Settings and Routings window.
Figure 9-7: Delete the connection highlighted above to turn off MMC
parsing in the MIDI Timepiece AV.
Setting up the Digital Timepiece
While you are still in ClockWorks, make the
following settings in the Digital Timepiece:
1
Select the Digital Timepiece in the Device List
window (if it isn’t already selected).
2 Set the Digital Timepiece’s sample rate to match
the DA-88.
3 In the MMC/Sync window, set the Digital
Timepiece’s time base mode to Word 1x/MTC .
Setting up Performer (or Digital Performer)
To set up Performer (or Digital Performer) to send
MMC commands to the SY-88 card:
1 Launch Performer and open the MIDI Machine
Control window.
Figure 9-8: Setting up control of the DA-88/SY-88 in Performer. Take
the Digital Timepiece and MIDI Timepiece AV off line, and bring the
DA-88/SY-88 on line.