ULTRAFRYER Systems PAR-3-HE, Руководство по эксплуатации

Страница: 38 / 65

30A135
e. EXIT MELT BUTTON - When this button is momentarily depressed, the melt cycle timing module in the
DTMR’s Default-to-Melt circuit will switch to the FULL-ON position allowing the Electronic Thermostat to
heat shortening to its PRE-SET temperature.
D. DTMR OPERATION - Prior to operating the Model PAR-3-HE Gas Fryer, ENSURE the Filter Tub Assembly is prop-
erly installed and DOCKED to the fryer’s Bulkhead socket and the Temperature Control Access Door is closed, the
fryer vat is filled with shortening to the middle of the “E” in the word LEVEL of the shortening level mark on the rear
wall of the vat; then:
1. Turn the Toggle ON/OFF Power Switch to the OFF Position.
2. Turn the MANUAL gas valve to the OFF position and wait
FIVE (5) minutes for any accumulated gas to disperse.
3. ENSURE the MAIN gas shut-off valve is in the ON posi-
tion, and that the EXHAUST FAN is ON.
4. Turn the MANUAL gas valve to the ON position.
5 . Perform the following steps, in the order listed:
ITEM ACTION DTMR CONDITION
1
ENSURE
the drain valve is in the CLOSED
UP
position and that shortening is at the proper
level; then turn the Toggle ON/OFF switch to the
ON position.
A.
AMBER
power lamp will
LIGHT
.
B. BLUE READY TO START lamp will LIGHT.
CAUTION: PRIOR TO PROCEEDING TO STEP 2 VISUALLY CHECK THAT THE HEAT ELEMENT IS
COVERED WITH AT LEAST 2” (51 mm) OF SHORTENING.
2
Depress, then release the momentary
START
button.
A. RED STARTED lamp and AMBER MELT MODE lamp will light.
B. BLUE READY TO START lamp will turn OFF.
C. The MELT CYCLE TIMING MODULE in the Default-To-Melt electrical circuit
will begin cycling the fryer heat mechanism
ON
for twelve (12) seconds and
OFF
for 28 seconds to safely heat the shortening.
CAUTION: PRIOR TO PROCEEDING TO STEP 3, VISUALLY CHECK THAT THE SHORTENING COMPLETELY COVERS
THE HEAT MECHANISM.
3
Depress, then release the momentary EXIT
MELT button.
A.
AMBER MELT MODE
lamp will turn
OFF, RED STARTED
lamp will
remain lit.
B. The
Melt Cycle Timing Module in the Default-To-Melt circuit will switch
to the FULL ON position allowing the Electronic Thermostat to heat
shortening to its pre-set temperature.
4
When the fryer’s pre-set temperature has
been reached, initiate a cook cycle.
Page 34 of 61