Ultra Lift 1500, Руководство по эксплуатации

Страница: 24 / 29

•
Apply Tri-Flow as follows:
o
Fully extend the Lift Frame. This can be done in the 4 Wheel
Dolly position or with the machine laying flat on the floor.
o
As you pull the power switch to raise the Lift Frame, spray
Tri-Flow directly onto the drive screw at the main hex nut.
Spray the entire length of the screw as the Lift Frame travels
upward.
NOTE! DO NOT SPRAY TRI-FLOW INTO THE
CLUTCH OR BRAKE!
o
When the entire screw has been sprayed, run the Lift Frame up
and down 2 or 3 times to throw off excess lubrication and any
dirt that might have been on the screw. This is a very important
procedure. If excess spray is left on the screw it can seep down
to the clutch or migrate up to the brake and affect operation.
b. Frame Rollers and Axles. On a monthly basis extend the Lift Frame
and spray Tri-Flow around the ends of the axles of all four frame rollers.
Run the machine up, down, and up again to disperse the spray.
c. Main Wheels. The two main wheels are provided with grease fittings.
Lubricate each wheel twice per year with lithium grease.
2. Rust Prevention
When you are required to use your Ultra Lift in rainy weather at the end of the
day, prior to battery charging, run the machine up and down to throw water
off the drive screw. Then wipe the machine off with a cloth. Pay
particular attention to the brake dust cover, drive screw and clutch. The
aluminum will not rust, but water setting on the aluminum can drip onto steel
drive system components.
3. Battery Charging
To obtain maximum battery life, it is essential that your Ultra Lift’s battery
be charged after each day of use. Charging instructions are provided on page
19 and page 20 of this manual.
-22-