Ultra Lift 1500, Руководство по эксплуатации

Страница: 4 / 29

1. STRAPPING THE LOAD
The adjustable Strap Bar can be positioned on the Lift Frame at the height required for the
particular load being moved. Mounting brackets welded to the back face of the Strap Bar
lock around the inside of the Lift Frame rails to hold the Strap Bar in place. See Figure 1
below:
Figure 1. Strap Bar Assembly
Bracket Cam Lock & Handle
Strap on Handle
1.
Mount the Strap Bar to the Lift Frame at the best position for the load being moved.
Open the strap handle as shown above and grip the handle end of the Strap Bar with
your left hand. Grip the cam lock end of the Strap Bar with your right hand.
2. Rotate the Strap Bar. Angle the Strap Bar so that the brackets can be moved between
the Lift Frame struts. With the Strap Bar in this position, place the back edge of the Strap
Bar against the front face of the Lift Frame struts.
3. Slide the top end of the Strap Bar sideways to lock one bracket around the Lift Frame
strut. Rotate the lower end upward until the second bracket locks behind the opposite
strut and continue to rotate until the Strap Bar is firmly locked in place.
Note: The Strap Bar brackets can be adjusted as required if the Strap Bar is either too tight
to fit onto the Lift Frame or is too loose and doesn’t stay in place. To adjust an overly tight
fit, lightly tap each bracket toward the center of the Strap Bar. To tighten a loose fit, lightly
tap the brackets out. Do this adjustment off the Ultra Lift.
Figure 2. Strapping Alternatives
One Strap Bar Two Strap Bars
-2-