Ultimaker S5 Material Station, Инструкция по установке и эксплуатации

Страница: 19 / 68

19
4.2 Print core installation
Print cores
The Ultimaker S5 uses two print cores in the print head, which are interchangeable.
There are two types of print cores:
•
Type AA: for printing build materials and Ultimaker Breakaway material
• Type BB: for printing water-soluble support material
Each Ultimaker S5 comes with two print cores AA 0.4 (of which one is already installed in print head slot 1) and one
print core BB 0.4. This means that it is possible to make prints with two build materials or with a build and support
material.
The print cores contain information on a small chip, so that the printer always knows which print cores are installed and
which materials can be used with this print core.
Install the second print core
During the welcome setup, the second print core must be installed. To do this, go to Print core 2 and select Start. Follow
the steps on the Ultimaker S5:
1. Carefully open the glass doors and the print head fan bracket and press Confirm.
2. Install the second print core (BB 0.4) in print head slot 2 by squeezing the levers of the print core and sliding it into
the print head until you hear a click.
Do not touch the contact points on the back of the print core with your fingers.
Make sure you keep the print core completely vertical while installing it so it will smoothly slide into the print
head.
3. Carefully close the print head fan bracket and Confirm to proceed with the welcome setup.