Ultimaker S5 Material Station, Инструкция по установке и эксплуатации

Страница: 37 / 68

37
5. Repeat step 4 for the front-left thumb wheel and Confirm to continue.
6. Place the calibration card inbetween the nozzle and build plate. Use the touchscreen controls to adjust the position
of the build plate until you feel some resistance when moving the card. Select Confirm to continue.
Do not apply force to the build plate while fine-tuning with the calibration card, as this will lead to leveling
inaccuracies.
7. Place the calibration card in between the nozzle and build plate in the front right corner. Adjust the thumb wheel
until you feel some resistance when moving the card. Confirm to continue.
8. Repeat step 7 for the front left corner and Confirm to continue.
After calibrating the build plate with the first nozzle, the second nozzle needs to be aligned as well, to ensure
the heights of both nozzles are set correctly. For this it is only necessary to set the correct height by using the
calibration card.
9. Place the calibration card inbetween the second nozzle and build plate. Use the controls to adjust the position of the
build plate until you feel some resistance when moving the card. Select Confirm to continue.
10. Wait for the printer to finish the manual leveling procedure.
XY offset calibration
Besides the vertical offset, the horizontal distance between the nozzles in the X and Y direction also needs to be
configured. The print cores that are supplied with the Ultimaker S5 are already calibrated, but when the printer detects a
new combination, you will need to perform an XY offset calibration again. This calibration must only be done once; after
this, the information is stored on the printer. A correct XY calibration will ensure that the two colors or materials align well.
To perform the calibration you will need an XY calibration sheet, which can found in the accessory box or
downloaded at www.ultimaker.com/XYcalibration.
Ensure 2 print cores and materials are installed before starting the calibration and that you have selected the correct XY
calibration sheet.
To start the calibration:
1. Go to Preferences
g Maintenance g Print head g Calibrate XY offset and select Start calibration.
2. The Ultimaker S5 will now print a grid pattern on the build plate. Wait until it is complete.
3. Once the Ultimaker S5 has cooled down, remove the build plate from the printer and align it with the XY calibration
sheet. Ensure the printed grid is precisely placed on/under the two rectangles on the sheet.
If you are performing the XY calibration on a glass build plate, the glass build plate must be placed on top of
the paper XY calibration sheet. For the aluminum build plate, place the transparent XY calibration sheet on top
of the plate.