UE Systems Ultraprobe 3000, Инструкция по эксплуатации

Страница: 29 / 35

Version 1 29
Locating faulty valves
Utilizing the contact (stethoscope) module in the Ultraprobe, valves can easily be monitored to
determine if a valve is operating properly. As a liquid or gas flows through a pipe, there is little or no
turbulence generated except at bends or obstacles. In the case of a leaking valve, the escaping
liquid or gas will move from a high to a low pressure area, creating turbulence on the low pressure
or "down-stream" side. This produces a white noise. The ultrasonic component of this "white noise"
is much stronger than the audible component. If a valve is leaking internally, the ultrasonic
emissions generated at the orifice site will be heard and noted on the meter. The sounds of a
leaking valve seat will vary depending upon the density of the liquid or gas. In some instances it will
be heard as a subtle
crackling sound, at other times as a loud rushing sound. Sound quality
depends on fluid viscosity and internal pipe pressure differentials.
As an ex-ample, water flowing under low to mid pressures may be easily recognized as water.
However, water under high pressure rushing through a partially open valve may sound very much
like steam. To discriminate: reduce the sensitivity, touch a steam line and listen to the sound
quality, then touch a water line. Once you have become familiar with the sound differences,
continue your inspection.
A properly seated valve will generate no sound. In some high pressure situations, the ultrasound
generated within the system will be so intense that surface waves will travel from other valves or
parts of the system and make it difficult to diagnose valve leakage. In this case it is still possible to
diagnose valve blow-through by comparing sonic intensity differences by reducing the sensitivity
and touching just upstream of the valve, at the valve seat and just downstream of the valve.
Procedure for valve check
1. Use stethoscope module.
2. Touch downstream side of valve and listen through headset.
3. When necessary, if there is too much sound, reduce sensitivity.
4. For comparative readings, usually in high pres-sure systems:
a. Touch upstream side and reduce sensitivity to minimize any sound (usually bring the
meter to a mid-line "50 %" reading).
b. Touch valve seat and/or downstream side.
Compare sonic differentials. If the valve is leaking, the sound level on the seat or down-
stream side will be equal to or louder than the upstream side.