UE Systems Ultraprobe 3000, Инструкция по эксплуатации

Страница: 12 / 35

Version 1 12
Setup mode
To enter the Set Up Mode:
1. Make sure the Ultraprobe is off.
2. Click (Press) the Sensitivity dial and hold it in. while you pull/squeeze the trigger. Hold both
the Sensitivity Dial and Trigger in until the screen displays: “ Menu 01; Send Records”.
NOTE: Hold the Trigger in during any of the Set Up Mode operations or the instrument will turn off.
3. Once Menu 01 is displayed, you may move to any of the other Menu Modes by spinning the
Sensitivity Dial up or down (clockwise or counter clockwise).
4. When the desired Menu Mode is reached, click (push) the Sensitivity Control in to enter/use
that menu function.
5. You may spin to enter and exit any Menu mode in the Set Up mode as long as the trigger is
squeezed to keep the instrument on.
01 Send Records
NOTE : Before downloading data, be sure the Ultraprobe is connected to the computer via the
USB cable.
To send data from the Ultraprobe to your computer:
1. Make sure the Ultraprobe is off.
2. Click (Press) the Sensitivity dial and hold it in. while you pull/squeeze the trigger. Hold both
the Sensitivity Dial and Trigger in until the screen displays: “ Menu 01; Send Records”.
NOTE: Hold the Trigger in during any of the Set Up Mode operations or the instrument will turn off .
3.
When Menu 01, Send Data is shown, “click” the Sensitivity Control Dial and all the data will
be transferred to the computer.
NOTE : For software management, refer to Ultratrend DMS Instructions.)
Menu 01
Send Data
02 Delete Records
To clear all records in preparation for your next route, you need to Delete Records.
1.
Enter Setup Mode…be sure to continue to hold the Trigger in.
2. Spin clockwise to Menu 02, Delete Records
3. You will see a prompt: Delete Records Confirm?
4. To exit, select NO
5.
To Delete, spin the Sensitivity Dial to YES and “click”(press) the Sensitivity dial