AeroCut XPro OPERATION MANUAL
53
38
FLEX MODE input error 3
Make sure for the first cut line must be 0.785” or
shorter from the edge of the paper.
If you want to cut off 0.785” or more, please cut
off 0.785” or less at first and then cut off again
and again.
If you try to move the slitter cut line at 1.85” or
more position, the slit will be ejected on Paper
ejection table instead of waste box.
42
Double feed error
Check the paper or paper path.
43
FLEX MODE input error 1
This error results when the three input values
shown in the following figure are “0” or lower at
FLEX MODE time.
45
Servo error
Servo motor error detected. Turn off the power,
and turn it on again after 5 seconds or longer.
48
FLEX MODE input error 4
Trailing edge error.
Correct the trailing edge to fit in the value
specified below.
52
Option unit error
１
Cable of X-Perforator has not been connected.
Connect the cable
